Seventenths
Member

1397 Likes

Page 72 of 94 First ... 225859606162636465666768697071727374757677787980818283848586 ... Last

• Jump to page:

1. 
   Tikka7mm08 liked post by Seventenths On thread : Short deer/pig/goat rifles for the tight stuff (lets see em)

   Here's one of my Ruger .44 magnum's I used to own, had a few over the years https://i.ibb.co/dWj8MXt/IMG-4846.jpg It was a 10/22 on steroids and hit like the hammer of Thor with a 240 gr XTP ...

   Liked On: 05-04-2020, 02:01 PM

2. 
   257weatherby liked post by Seventenths On thread : .243win bushpig hand load help

   Your over thinking it all, when you say your shooting animals no further than 50 metres then the velocity your getting is fine. In my Remington Model 7 I ran 95 gr Targex projectiles behind 43 gr...

   Liked On: 03-04-2020, 02:47 PM

3. 
   Steelisreal liked post by Seventenths On thread : Pistol Registry

   As gundoc says if you swop out the barrel & pistol grip to rifle furniture making it longer than 762 mm then you have a rifle. However... the serial number which I believe on the contender is on...

   Liked On: 03-04-2020, 02:45 PM

4. 
   superdiver liked post by Seventenths On thread : Short barrel 243

   I was running a Remington Model 7 .243 shooting 95 gr Targex projectiles behind some AR2209 which did a fine job on Sika & Fallow. Never tried any factory loads but people always rave about the...

   Liked On: 30-03-2020, 09:41 PM

5. 
   stagstalker liked post by Seventenths On thread : . 284 Winchester

   I've had a .284 Win for the past few years where it was a reamed out 7mm-08 T3 by Gunworks who did a dam fine job. The barrel was cut back to 16 inches with a DPT suppressor and that rifle simply...

   Liked On: 08-02-2020, 05:33 PM

6. 
   zimmer liked post by Seventenths On thread : . 284 Winchester

   I've had a .284 Win for the past few years where it was a reamed out 7mm-08 T3 by Gunworks who did a dam fine job. The barrel was cut back to 16 inches with a DPT suppressor and that rifle simply...

   Liked On: 08-02-2020, 02:51 PM

7. 
   7mmsaum liked post by Seventenths On thread : 223 projectiles

   I used a 55 gr Sierra (#1345) alot on Fallow & Sika with great results. Recently switched to a Sierra 63 gr SMP (#1370) which has also been very good. I tried the 55 gr Hornady projectiles and...

   Liked On: 07-02-2020, 06:37 PM

8. 
   planenutz liked post by Seventenths On thread : 223 projectiles

   I used a 55 gr Sierra (#1345) alot on Fallow & Sika with great results. Recently switched to a Sierra 63 gr SMP (#1370) which has also been very good. I tried the 55 gr Hornady projectiles and...

   Liked On: 07-02-2020, 06:21 PM

9. 
   Pommy liked post by Seventenths On thread : Need 6.5 Creedmore load for Tikka rifle

   Re read my initial post... especially paragraph 3 :thumbsup:

   Liked On: 05-02-2020, 11:18 AM

10. 
    10-Ring liked post by Seventenths On thread : Need 6.5 Creedmore load for Tikka rifle

    Re read my initial post... especially paragraph 3 :thumbsup:

    Liked On: 04-02-2020, 10:07 PM

11. 
    Bigash liked post by Seventenths On thread : Need 6.5 Creedmore load for Tikka rifle

    Cheers... whats the COAL?

    Liked On: 02-02-2020, 08:11 PM

12. 
    Micky Duck liked post by Seventenths On thread : Need 6.5 Creedmore load for Tikka rifle

    Team, a mate has just acquired a Tikka T3 in 6.5 Creedmore so I've looked through the search engine on the forum but can't find anything for the calibre and rifle to help get him started. If...

    Liked On: 02-02-2020, 07:48 PM

13. 
    funkin_d liked post by Seventenths On thread : Kimber 84M or Tikka T3x? Advice please

    I have both a kimber Montana in 7mm-08 & a couple of T3’s in various calibres. Both are different Kimber - Winchester pre 64 control fed action with internal magazine (no floor plate),...

    Liked On: 20-01-2020, 09:48 PM

14. 
    Micky Duck liked post by Seventenths On thread : Kimber 84M or Tikka T3x? Advice please

    I have both a kimber Montana in 7mm-08 & a couple of T3’s in various calibres. Both are different Kimber - Winchester pre 64 control fed action with internal magazine (no floor plate),...

    Liked On: 20-01-2020, 08:26 PM

15. 
    dogmatix liked post by Seventenths On thread : SMLE restoration update.

    That’s stunning. GREAT job and look forward to reading the rest. Are you bedding the rifle yourself? What bedding compound are you gonna use?

    Liked On: 20-01-2020, 12:16 PM

Page 72 of 94 First ... 225859606162636465666768697071727374757677787980818283848586 ... Last

• Jump to page: