Greetings, Chamfer the inside and outside of the mouths to remove any roughness. If there are any dings in the mouths run your expander button in and out of the case mouth BUT DO NOT REPEAT NOT FULL...
Liked On: 28-12-2023, 04:09 PM
could also deburr flash holes as well. you only need to do it once
Liked On: 28-12-2023, 04:09 PM
That is a beautiful looking bit of kit!!! If those are the three little pigs, you must be the big bad wolf!
Liked On: 27-12-2023, 03:54 PM
They tell me that that's the 'right' orientation - it's when it is 90deg to the pistol grip or roughly parallel with the barrel that the amount of surface area of the growth lines/grain in the pistol...
Liked On: 27-12-2023, 03:53 PM
It’s all my fault. 239410
Liked On: 24-12-2023, 12:52 AM
Bolts can get lost very easily. Found this one for the very happy owner after back tracking over every step we had made during the day. Looked down while standing in the stream bed and hey...
Liked On: 24-12-2023, 12:50 AM
Here you go mate: https://www.youtube.com/watch?v=nueM_Q7yPwY Just filmed how to re-cock it on a wooden bench to show you. You're here: 239957 You want to be here: 239958
Liked On: 24-12-2023, 12:38 AM
So 3 days hunting in the West Coast and first evening a hind at 170m became the first victim of the 1885 30-40 U.S. Govt I did hit it a little higher than I intended But it dropped in the spot...
Liked On: 24-12-2023, 12:22 AM
I finally resolved my load conundrum when Hornady 180 grain RN bullets became available again Found a load using W760 that the rifle seems to like. Loaded plenty, checked the sights and decided...
Liked On: 24-12-2023, 12:21 AM
I own multiple pairs of crocs and use bahco knives Thank you for your feedback
Liked On: 24-12-2023, 12:17 AM
They are a crime against fashion. Think crocs and mullets.
Liked On: 24-12-2023, 12:17 AM
Im sure he was going to register come closer to the time:)
Liked On: 24-12-2023, 12:14 AM
Way back, when battery grinders came on the scene I read somewhere that if your safe could survive, without entry, 2 cutoff disks and one backup battery it was deemed to have provided reasonable...
Liked On: 23-12-2023, 11:52 PM
A good one is reinforcing mesh sandwiched between sheets of 18mm MDF, if they use a skilsaw, they'll have teeth flying at them and if they use a grinder they'll suffocate themselves on the smoke....
Liked On: 23-12-2023, 11:47 PM
makes me wonder if putting plywood boxing around outside and encasing in a good 100mm of concrete has merit..sure as shit would stop it being carried away LOL.
Liked On: 23-12-2023, 11:46 PM