shooternz
Member

911 Likes

Page 17 of 61 First ... 345678910111213141516171819202122232425262728293031 ... Last

• Jump to page:

1. 
   shooternz liked post by Micky Duck On thread : DONT TAKE KIDS HUNTING!

   yip happened 2 years ago...if you know the area its not so strange afterall....went to high school in Taumarunui and many of us used to hunt possums each n every weekend. school kids in same area...

   Liked On: 07-06-2020, 11:18 AM

2. 
   shooternz liked post by gundoc On thread : Alliant bullseye powder

   Bullseye has long been a popular powder for pistol target loads but probably a bit scarce these days. I use Winchester Super Target for .38 Special, 9mm and .45 ACP. For my 10mm I use Winchester...

   Liked On: 07-06-2020, 02:08 AM

3. 
   shooternz liked post by Cigar On thread : Subsonic load for 308

   I seat so that the case mouth is at the top groove in your photo. I don’t load to an OAL with the cast bullets, I don’t even measure them.

   Liked On: 02-06-2020, 06:18 PM

4. 
   shooternz liked post by Gkp On thread : 6.5x55 SE Sanity Check

   Increase powder charge by 0.5 for each load. Shoot a 3 shot group working your way up, rem bering to let your barrel cool down between groups. Take note of the accuracy, you should hit a sweet spot...

   Liked On: 29-05-2020, 01:27 AM

5. 
   shooternz liked post by Marty Henry On thread : 6.5x55 SE Sanity Check

   Chase accuracy not speed, that's what the swede is famed for, anything over 2600 fps will be perfectly adequate for hunting out to 3-400 ydswith that bullet. I use 2206h in my m38 sporterised with...

   Liked On: 29-05-2020, 01:26 AM

6. 
   shooternz liked post by winaa On thread : Once Fired Brass Worth

   Brand new Hornady is around $89/50 ($178/100) Norma is around $167/100. Once fired is worth 1/2 that in my book

   Liked On: 18-05-2020, 06:50 PM

7. 
   shooternz liked post by jim160 On thread : Resizing. 308 to .243, help?? Or a dumb idea?

   Maybe trade them or sell and buy new.

   Liked On: 18-05-2020, 06:47 PM

8. 
   shooternz liked post by stug On thread : can't leave well enough alone 7mm rem mag 180gn eldm and VLD

   162 is the optimum weight in 7mm mag. You don’t gain enough by going to 180gr. What you gain in BC you lose in velocity and extra recoil. To really get the advantage of 180’s you need more case size....

   Liked On: 09-05-2020, 12:52 PM

9. 
   shooternz liked post by janleroux On thread : Decapping live primers

   When I had to remove live primers in the past, I filled the cases with water to kill the primer, then tip the water out and decap them as per usual. Sent from my iPhone using Tapatalk

   Liked On: 09-05-2020, 12:47 PM

10. 
    shooternz liked post by Bagheera On thread : Shooting training

    Hi Joe, Practice is good but you need to practice good technique. Mimms is right - it starts with the feet and whatever part of you is on the ground. Technique and specially position do vary...

    Liked On: 05-05-2020, 10:07 AM

11. 
    shooternz liked post by zimmer On thread : bullet help please

    Blisters 50 years ago milsurp 30-06 was my main source of ammo for my 308W. At the time 308W was a prohibited import and only CAC factory was available. The govt of the day protected the local...

    Liked On: 29-04-2020, 11:59 AM

12. 
    shooternz liked post by 257weatherby On thread : 25-06 why hasn't it achieved fame and success in New Zealand?

    Perhaps you would like to share your actual practical experience with killing animals with a 2506, rather than cherry picked numbers from the internet to suit your given position. A typical load for...

    Liked On: 10-03-2020, 11:37 AM

13. 
    shooternz liked post by On thread : See separation?

    thar has invented a new sabot wildcat :thumbsup: Mooseman i find federal brass the worst ive tried as far as enlarged primer pockets go

    Liked On: 07-03-2020, 01:09 PM

14. 
    shooternz liked post by Mooseman On thread : See separation?

    Do you really need to anneal the cases, have reloaded for 40 plus years and never annealed any of my brass. I do get split necks after a while but usually get quite a few loads from them before this...

    Liked On: 07-03-2020, 01:08 PM

15. 
    shooternz liked post by Pommy On thread : 300BLK questions

    No worries. Bill999's absolutely right and I had a similar experience getting the buggers seated. Ended up buying a Lyman 30M1 expander die which helped and used the hot glue gun trick on a spare...

    Liked On: 06-03-2020, 01:54 PM

Page 17 of 61 First ... 345678910111213141516171819202122232425262728293031 ... Last

• Jump to page: