Finally got mine underway, very much a make it up as I go along build, I know bugger all about caravans apart from watching 'Snatch'. Jayco Chassis which I've raised a bit to make it a bit better...
Liked On: 18-04-2021, 10:38 PM
I may get criticised for saying this, but whatever. A slingshot doesn't draw anywhere near the same level of scrutiny as a firearm, plus it can be tucked away in a backpack. If you have permission to...
Liked On: 14-04-2021, 09:10 AM
Greetings Mooseman, It can just be a loose extractor and will vary with the pressure of the loads. For whatever reason the bolt lift is not doing its job of starting the case out of the chamber...
Liked On: 31-03-2021, 08:37 AM
It will be a contributing factor. Likely a combination of poor primary extraction, possibly dirty chamber, oversize brass/undersize chamber, hot loads. It will be at least two of those problems with...
Liked On: 31-03-2021, 08:37 AM
I got it that way, Gunworks down here do it routinely for about a ton.
Liked On: 30-03-2021, 10:03 PM
Snap! 164038
Liked On: 30-03-2021, 08:13 PM
Greetings Mooseman and all, I have watched tis thread for a bit. The main problem is that the primary extraction of the rifle is defective and needs to be fixed. MSL suggested tis in post 3 and...
Liked On: 30-03-2021, 02:23 PM
What I do is vacuum pack the backsteaks and place in fridge for 1 to 2 weeks, all the rest goes straight into the freezer for mince, sausages or patties Hamish Sent from my SM-G960F using...
Liked On: 30-03-2021, 08:18 AM
I've got a mate who's a stock agent and has a Rexton it's 2 years old and done over 200,000 and heaps of that on Otago gravel roads and he reckons you just poke some diesel in it and change the oil...
Liked On: 22-03-2021, 11:51 AM
I'll get flamed no doubt but the mq tritons rate as one of the most reliable vehicles out there. If it was my money I would be looking for a low k Triton or Dmax.
Liked On: 22-03-2021, 11:09 AM
No primary extraction? Sent from my iPhone using Tapatalk
Liked On: 21-03-2021, 04:04 PM
All good, but I just wouldn't give him the thread to start pulling on. Let the neighbor put in the effort and do his own research if he feels so strongly.
Liked On: 19-03-2021, 09:39 PM
I used moly grease and found similar. I now use CLP oil on the threads. Also, when putting the can away for storage I break the seal on all the sections so a gap shows. To get any seized sections...
Liked On: 08-03-2021, 11:04 AM
Yup.
Liked On: 25-02-2021, 10:43 AM
Sluice, pans,detector, 4x4 fly >15kg.
Liked On: 31-12-2020, 01:52 PM