stevodog
Banned

484 Likes

Page 9 of 33 First 1234567891011121314151617181920212223 ... Last

• Jump to page:

1. 
   stevodog liked post by stagstalker On thread : 7mm Rem Mag Browning X-Bolt Hell’s Canyon Reload Advice

   IMR4831 worked very well in my Tikka 7mm Rem Mag with the 162 ELD-X at 20thou jump.

   Liked On: 02-09-2020, 08:03 AM

2. 
   stevodog liked post by grandpamac On thread : 6.5x55 SE Sanity Check

   Greetings Magnetite, Looks like your rifle gives a little more velocity than mine with your selection of components. I note that you are using a suppressor which some suggest gives more velocity so...

   Liked On: 01-09-2020, 10:54 AM

3. 
   stevodog liked post by Frogfeatures On thread : Warthog V Sharp

   You’ve been peeking in his window again, haven’t you ?

   Liked On: 28-08-2020, 02:50 PM

4. 
   stevodog liked post by 2post On thread : Vehicle security while in the bush.

   An old man that was friends with my dad had a tap on the fuel line, he just reached under the side of the car to open and shut it, The car would start but only go 100m which puts them more in the...

   Liked On: 27-08-2020, 11:30 AM

5. 
   stevodog liked post by res On thread : Vehicle security while in the bush.

   Thanks for this tip, Ill be adding it to my bag of tricks

   Liked On: 27-08-2020, 11:29 AM

6. 
   stevodog liked post by Micky Duck On thread : Vehicle security while in the bush.

   I park on a shit of an angle so anyone trying to jack it up is likely to end up squashed under it....if they actually manage to get jack to lift before it crabs sideways... and it was me that said...

   Liked On: 27-08-2020, 11:29 AM

7. 
   stevodog liked post by dannyb On thread : Tikka 7mm rem mag

   162gn eldm with either 2225 powder or 2217 will do the buisness all day I have played with a few bergers and barnes but the eldm are not fussy, get em going about 3000fps give or take 50fps and...

   Liked On: 24-08-2020, 11:07 PM

8. 
   stevodog liked post by Gkp On thread : Barnes 120gr TTSX in 6.5mm Creedmoor

   As other have said above; shot placement and velocity is important. The mono need speed to be effective as they don't have a soft core like lead core bullets. The weight of the bullet is not...

   Liked On: 23-08-2020, 11:12 AM

9. 
   stevodog liked post by dannyb On thread : Barnes 120gr TTSX in 6.5mm Creedmoor

   I'm going to be trying the 110 gn ttsx in my 270win hoping for 3260fps which should be achievable with adi 2209 powder That would see a light recoil, super flat trajectory (4" drop at 400 yards) and...

   Liked On: 22-08-2020, 11:26 PM

10. 
    stevodog liked post by Brian On thread : Barnes 120gr TTSX in 6.5mm Creedmoor

    I shoot 6.5 ttsx 100 gr at 3300fps (not a creedmore). 350 yds is fine I don't know where they run out of steam but have dropped a big boddied stag on the spot at 380.

    Liked On: 22-08-2020, 11:25 PM

11. 
    stevodog liked post by Micky Duck On thread : Barnes 120gr TTSX in 6.5mm Creedmoor

    at 350mtrs you will be FAR better off with a cup n core...barnes work their magic up close n personal at fastest speed you can get...where they are good they are great...out further with lower...

    Liked On: 22-08-2020, 06:28 PM

12. 
    stevodog liked post by superdiver On thread : Barnes 120gr TTSX in 6.5mm Creedmoor

    Wouldn't you go 100gr to get the speed?

    Liked On: 22-08-2020, 06:27 PM

13. 
    stevodog liked post by Wingman On thread : Fireforming case with cleaning patches and pistol powder

    Ive found the best method for all my wildcats/Ackley's etc is a full to the brim case of Trailboss then stab it into a candle to seal with a plug of wax. Most cases will form fully this way and its...

    Liked On: 21-08-2020, 04:55 PM

14. 
    stevodog liked post by 25 /08 IMP On thread : Fireforming case with cleaning patches and pistol powder

    I've used the cream of wheat method and a few others but I found just using a standard load the best they still shoot accurate and are good for steel shoots or hunting. Sent from my CPH1903 using...

    Liked On: 21-08-2020, 04:48 PM

15. 
    stevodog liked post by ebf On thread : Fireforming case with cleaning patches and pistol powder

    If you want good conformity of the brass to your chamber, you really want to use a projectile and get it jammed into the lands, so that the case base is tight against the bolt face. That way you get...

    Liked On: 21-08-2020, 04:48 PM

Page 9 of 33 First 1234567891011121314151617181920212223 ... Last

• Jump to page: