Looks like an error is occurring mate
Liked On: 07-07-2018, 05:06 PM
Resale. Sent from my SM-G965F using Tapatalk
Liked On: 20-06-2018, 11:08 PM
Well got this newly acquired Ruger M77 Hawkeye in 6.5x55 Swede all dressed up. Wearing a custom mix of McMillan Tan & McMillan Green she sits nicely in a hydro-dipped synthetic stock (Auckland...
Liked On: 20-06-2018, 08:34 PM
Well another job complete... Ruger M77 Hawkeye, re-barreled & chambered by Hugh Bradley at Bradley Barrels in .22-243. Took a while to decide on colour but have gone for Titanium, I think it sits...
Liked On: 20-06-2018, 08:34 PM
The more you know. I always thought the stainless was more expensive. Sent from my TA-1024 using Tapatalk
Liked On: 20-06-2018, 08:33 PM
Come on guys this WAS a good thread.
Liked On: 16-06-2018, 07:00 PM
I have never had direct dealings with DPT, but from the feedback from people who have, I have heard good things, but I have had a poor customer experience with Hardys and have heard similar things....
Liked On: 07-06-2018, 06:57 PM
If it comes back to a person I would say they need a better picture. However, I would of thought all responsibility came back to the owner, in that case your screwed.
Liked On: 29-05-2018, 06:58 PM
I have not read this whole thread, however the store does have (one) opportunity to rectify the issue before you are entitled to a refund or replacement. A serious fault would be a major issue, the...
Liked On: 07-05-2018, 03:19 PM
I've got Phil all figured out now, what he does is when he's about to do something, like cook, or skin a chamois, he starts on some long winded story untill you eventually just do it yourself haha
Liked On: 06-05-2018, 09:12 PM
As one who has done an awful lot of this type of job for the various importers over the years, I can assure you that the job is both minor and routine. Probably only about 15 minutes of work. ...
Liked On: 05-05-2018, 03:05 PM
https://www.consumer.org.nz/articles/returns-and-refunds
Liked On: 05-05-2018, 01:14 PM
Long brushes to get the epoxy where it needs to be, then for the butt & wrist I sort-of roll the CF strip into place using a long stick and prod it into place. I do this with the epoxy wet so I can...
Liked On: 03-05-2018, 11:07 PM
Strips of carbon fibre inside the stock after glueing the sides together much like two halves of a plastic model aeroplane.
Liked On: 02-05-2018, 12:52 PM
That's what I was wondering. its a neat process!!
Liked On: 02-05-2018, 12:52 PM