T.FOYE
Member

337 Likes

Page 4 of 23 First 123456789101112131415161718 ... Last

• Jump to page:

1. 
   T.FOYE liked post by akaroa1 On thread : What Have You Loaded Today

   I loaded some 500 3" BPE I'm already on plan C for this roar and the way things are going anything could happen. So roll up some of these and then have options for plan D, E and F 246640 ...

   Liked On: 25-03-2024, 06:50 AM

2. 
   T.FOYE liked post by Marty Henry On thread : BAD FLYER 9"

   A tip coming loose on loading and lying to one side on firing wedging against the projectile could account for it. I've had tips shatter on the breech face when single loading and the round hasn't...

   Liked On: 25-03-2024, 06:43 AM

3. 
   T.FOYE liked post by Kimber 7mm-08 On thread : BAD FLYER 9"

   Baffle strike or loose suppressor?

   Liked On: 25-03-2024, 06:40 AM

4. 
   T.FOYE liked post by john m On thread : What Have You Loaded Today

   I loaded some 30-30 with the 160 ftx and 32.5 gr of AR2208. 246518 I then tested them at 100yds aiming at the black square using a rolled up coat for a rest. Good group but left so corrected and...

   Liked On: 23-03-2024, 08:05 PM

5. 
   T.FOYE liked post by Jhon On thread : Moving to NZ from US

   Sell it, use the $$$ to buy what you want here..cost you more than Pistol is worth just to get it out of the US. Get a quote from a couple of FFL dealers. And that's before you contemplate NZ regs

   Liked On: 21-03-2024, 06:11 AM

6. 
   T.FOYE liked post by Jhon On thread : 45/70 projectiles

   Flat point /truncated cone, should give you a lot better wound channel than Round nose, yes? What Elmer Keith was all about, right?

   Liked On: 18-03-2024, 10:52 PM

7. 
   T.FOYE liked post by Barry the hunter On thread : Things are getting desperate

   can you cast them solid lead

   Liked On: 18-03-2024, 06:23 AM

8. 
   T.FOYE liked post by tikka On thread : What Have You Loaded Today

   That die does a tidy job

   Liked On: 03-03-2024, 09:58 PM

9. 
   T.FOYE liked post by Micky Duck On thread : What Have You Loaded Today

   leave them in there..the puke green ones turn them into zombiemax loads LOL.

   Liked On: 03-03-2024, 09:57 PM

10. 
    T.FOYE liked post by Bobba On thread : What Have You Loaded Today

    Loaded up a ladder for the 284. 150 eldx with 2209 and RL17. 245085

    Liked On: 03-03-2024, 09:56 PM

11. 
    T.FOYE liked post by tikka On thread : What Have You Loaded Today

    Did some 55gr soft points 223 subsonics for myself on my gear and help a couple of mates setup there new reloading gear, show them how too set the dies for 6.5x55 and did some 129gr corelock test...

    Liked On: 03-03-2024, 03:39 PM

12. 
    T.FOYE liked post by 30.06king On thread : What Have You Loaded Today

    Some .375 Ruger with Barnes TSX 270 gn loaded today for shooting tomorrow. Load development work. I think a useable load is sorted but have been getting flyers from the third shot in the magazine....

    Liked On: 21-02-2024, 09:52 PM

13. 
    T.FOYE liked post by Marty Henry On thread : What Have You Loaded Today

    I have no idea of temp, lee pot dropped to 4 setting. I use a ladle not the drippy bottom spout. If it runs like water it's good to go wait till the sprues changed colour then cut and drop onto...

    Liked On: 19-02-2024, 08:26 PM

14. 
    T.FOYE liked post by Marty Henry On thread : What Have You Loaded Today

    40 rounds of 45/70, 405 cast, beeswax lard mix lube, 60 gr 2f, 40 38/55 cast 285 lead with smokeless, 35 577/450 480 gr cast beeswax lube over 70 gr 2f. Today casting a wodge of replacement...

    Liked On: 19-02-2024, 11:06 AM

15. 
    T.FOYE liked post by akaroa1 On thread : What Have You Loaded Today

    244057

    Liked On: 18-02-2024, 10:32 PM

Page 4 of 23 First 123456789101112131415161718 ... Last

• Jump to page: