tikka6.5
Member

38 Likes

Page 1 of 3 123 Last

• Jump to page:

1. 
   tikka6.5 liked post by 7mm tragic On thread : I need advice for buying a fishing boat

   Um, this could be a bit like 'what's the best caliber for shooting deer?' If you can, try and get a 4 stroke, you will appreciate the fuel economy over a 2 stroke. Direct injection 2 strokes are...

   Liked On: 28-09-2024, 10:35 PM

2. 
   tikka6.5 liked post by tac a1 On thread : Help removing striped screws

   Dont muck around. Take it to the gunsmith.

   Liked On: 25-07-2024, 10:22 PM

3. 
   tikka6.5 liked post by 6.5 CRD On thread : 6.5 staball vs 2209

   6.5 Staball will give more speed but at the sacrifice of temp sensitivity. If you have a good load sorted already with 2209, i would stick with that. If you look hard enough, you will find some. Bit...

   Liked On: 04-09-2023, 10:37 PM

4. 
   tikka6.5 liked post by Skirch On thread : 6.5 staball vs 2209

   Man, your probably stressing over nothing. Just do some ladder testing to make sure it's safe and put a new load together. They designed it to be less temp sensitive than normal ball powders. And...

   Liked On: 04-09-2023, 10:37 PM

5. 
   tikka6.5 liked post by Beetroot On thread : 6.5 staball vs 2209

   Last time I looked there was still some 2209 floating around the latest shipment of ADI didn't sell out instantly like previous ones. If you have ample primers then go ahead and develop a load...

   Liked On: 04-09-2023, 10:37 PM

6. 
   tikka6.5 liked post by Pommy On thread : 6.5 staball vs 2209

   You should be able to use StaBall to drive a 130-143gr bullet to at least the same velocity as you get with 2209. So yes it's a viable backup option in that sense. It might not be 42gr that does...

   Liked On: 04-09-2023, 10:37 PM

7. 
   tikka6.5 liked post by Longrun On thread : 6.5 staball vs 2209

   Ive a stash that I'll use in 250savage,260,6.5x55,and 708 after my w760 runs out.

   Liked On: 03-09-2023, 02:01 PM

8. 
   tikka6.5 liked post by csmiffy On thread : 6.5 staball vs 2209

   Quickly looked up the data for stability 6.5 for the 243 on the hogdon site. Got a 100gps and change over 2209 but their max pressure was 8000psi higher too. Obviously there is the science of slower...

   Liked On: 03-09-2023, 01:46 PM

9. 
   tikka6.5 liked post by Beetroot On thread : 6.5 staball vs 2209

   StaBall should be faser but being a ball power you will likely find you are able to fit more powder into the case than 2209, so you'll get higher velocities but be burning more powder (not a crazy...

   Liked On: 03-09-2023, 01:39 PM

10. 
    tikka6.5 liked post by Tentman On thread : Large vs small

    Interesting observations. My current experiments with cartridges that run both sizes have left me scratching my head. In 224 Valkyrie and 6.8SPC I have brass with both sizes. Using 224V Starline...

    Liked On: 22-08-2023, 10:21 PM

11. 
    tikka6.5 liked post by Kiwi Greg On thread : Large vs small

    SRPs work great with fast powers, ie 308, not so good with slower powders 6.5 CM Also some rifles like RPR's don't hold hands well with SRP & top end loads, the firing pin is to big & primer too...

    Liked On: 22-08-2023, 10:21 PM

12. 
    tikka6.5 liked post by NakiNewbie On thread : Helping to collect and send some gear from Christchurch to the NI

    Cheers gents, that’s great! I’ll reach out if successful

    Liked On: 20-08-2023, 08:03 PM

13. 
    tikka6.5 liked post by zimmer On thread : Large vs small

    I'm running 308 SRP in Lapua and Peterson. Need to factor in the fact that the cost of SRP Lapua Palma is greater than LRP Lapua. And it seems that the Palma brass usually disappears off the shelves...

    Liked On: 20-08-2023, 06:04 PM

14. 
    tikka6.5 liked post by johnd On thread : Large vs small

    When I ran SRP in a 6.5 Creedmoor I had hang fires with feds and Belmont 760, swapped primers issue went away. Ball powder large charge and mild spark didn't mix well. Out of a string of 10 I found...

    Liked On: 20-08-2023, 06:04 PM

15. 
    tikka6.5 liked post by grandpamac On thread : Large vs small

    Greetings, Ball powders are harder to ignite and some older manuals recommended using Large Rifle Magnum primers for them. GPM.

    Liked On: 20-08-2023, 06:03 PM

Page 1 of 3 123 Last

• Jump to page: