Tommy
Member

4943 Likes

Page 214 of 330 First ... 114164200201202203204205206207208209210211212213214215216217218219220221222223224225226227228264314 ... Last

• Jump to page:

1. 
   Tommy liked post by 6x47 On thread : What bullet for 223 and goats?

   If you're only shooting goats, it's a bit like asking what size hammer do you need to kill ants. Short of FMJs or ultra-explosive varmint options, anything in the middle will do, long as it's...

   Liked On: 27-07-2016, 07:38 PM

2. 
   Tommy liked post by Munsey On thread : Bait board and under floor fuel tank.

   Firstly Make a prototype I'll test it out for you ;)

   Liked On: 26-07-2016, 09:07 PM

3. 
   Tommy liked post by veitnamcam On thread : Stag do idears

   For ten grand I would buy a boat and take my mates fishing in that. Actually I did do that.

   Liked On: 24-07-2016, 09:33 PM

4. 
   Tommy liked post by Tikka7mm08 On thread : Gun Porn, show off your new toys

   Man cave...must tidy. Train table taken over by powder supplies... http://uploads.tapatalk-cdn.com/20160724/39dec355cb5752645ae17ed1059bd0f7.jpg ...

   Liked On: 24-07-2016, 09:24 PM

5. 
   Tommy liked post by Beaker On thread : Gun Porn, show off your new toys

   The daughter turns 4 next month, so some may say to young, however she is a switched on kid, and I reckon will go OK. Just nice and easy for a start..... and if she doesn't like it, she doesn't like...

   Liked On: 24-07-2016, 09:22 PM

6. 
   Tommy liked post by Beaker On thread : Gun Porn, show off your new toys

   As a b day gift for the daughter ( in a few weeks, she's been on at me to get her one for about a year....). Had to go and give it a go, to make sure all was OK etc.... :) impressed with the...

   Liked On: 24-07-2016, 09:21 PM

7. 
   Tommy liked post by homebrew.357 On thread : Makeing a double paper patch mould

   Ok, now the next bit is to machine two of the ali blocks faces true, again set up in chuck and skim one face on each block. Now the two faces will be the inside of the mould but before drilling the...

   Liked On: 24-07-2016, 09:09 PM

8. 
   Tommy liked post by Bonecrusher On thread : Stag do idears

   Work phone with a recycled number man the drug deals, slappers that the previous owner got rung about :thumbsup:

   Liked On: 24-07-2016, 09:02 PM

9. 
   Tommy liked post by veitnamcam On thread : Stag do idears

   Plenty of options, pick a destination and date and do it. I had mine in a forestry camp in/near port underwood...fishing,pigs and goats. My best mate had his in a woolshed near Kahurangi, farking...

   Liked On: 24-07-2016, 09:02 PM

10. 
    Tommy liked post by R93 On thread : Stag do idears

    If ya pay me in booze I am a well below average pole dancer😆 Sent from my SM-G900F using Tapatalk

    Liked On: 24-07-2016, 09:00 PM

11. 
    Tommy liked post by viper On thread : Beam scales vs Electronic

    Yeah your right FrogFeatures, I hated reloading the first time I started but his time round my head is in a different space and I just cruise out and slowly work through it . Measure every load so...

    Liked On: 24-07-2016, 08:01 PM

12. 
    Tommy liked post by Lux On thread : Hi guys and Gals

    Hi im Stefan from Tauranga been reading a lot on here lately looking into joining the CNIGC and getting my E cat this year really liking the look of the DD m4. Look foward to meeting new people and...

    Liked On: 24-07-2016, 09:54 AM

13. 
    Tommy liked post by gonetropo On thread : .22 Subs performance

    i learned the hard way never use remington rimfire ammo in a semi auto, horribly dirty stuff

    Liked On: 23-07-2016, 12:48 PM

14. 
    Tommy liked post by Beaker On thread : WTF!!! No bang!

    :useless: of the intended end use......

    Liked On: 21-07-2016, 09:15 PM

15. 
    Tommy liked post by mikee On thread : Sending a gun by courier to gun shop - quick advice!

    Should I apply for my dealers licence to make it easier for ya to MT my wallet ?? :) :)

    Liked On: 20-07-2016, 09:08 PM

Page 214 of 330 First ... 114164200201202203204205206207208209210211212213214215216217218219220221222223224225226227228264314 ... Last

• Jump to page: