Wingman
Member

2384 Likes

Page 75 of 159 First ... 256162636465666768697071727374757677787980818283848586878889125 ... Last

• Jump to page:

1. 
   stagstalker liked post by Wingman On thread : 6.5 ELD-M 140 vs 147....ELD-X?

   41.gr RL16 Lapua SRP Brass CCI BR-4. No pressure but I took it up to 2770fps which showed the start of cratering but not flat primers and groups opened up as I went past the 41gr. Longest Red...

   Liked On: 13-10-2020, 03:20 PM

2. 
   stagstalker liked post by Wingman On thread : 6.5 ELD-M 140 vs 147....ELD-X?

   I found the 147gr ELDMs out shot the 143ge ELDX in both my creedmoor barrels and the .260Rem. Even though its heavier than the 140gr and 143gr I found the 147gr gets higher velocities before pressure...

   Liked On: 13-10-2020, 03:20 PM

3. 
   Kiwi Sapper liked post by Wingman On thread : Paradise Duckling

   I have a couple of clucky hens and ducks at the moment, they will be happy to take care of it if you are unable. Important to keep them warm at night with a heat source such as a red heat lamp as...

   Liked On: 12-10-2020, 03:07 PM

4. 
   mark kiwi liked post by Wingman On thread : Remington 700 Bullpup chassis build

   Ive been favouring my Grendel and .223 AI lately so the Creedmore pup has been neglected. Due to the frequent evening thunderstorms and higher winds it was however perfect for a late afternoon lay...

   Liked On: 02-10-2020, 09:50 AM

5. 
   mark kiwi liked post by Wingman On thread : 6.5 Creedmoor load development

   This stage of the development is were it got hairy and disappointing and I very nearly scrapped the cal all together. From here on my once fired Lapua small primer brass was tumbled OAL trimmed,...

   Liked On: 02-10-2020, 09:28 AM

6. 
   mark kiwi liked post by Wingman On thread : 6.5 Creedmoor load development

   Yip this will be a lengthy thread boys so sit back and grab a brew, Ill add to this write up over the next few days and as time allows Now before I even start on the journey to velocity and...

   Liked On: 02-10-2020, 09:24 AM

7. 
   mark kiwi liked post by Wingman On thread : 6.5 Creedmoor load development

   I have fairly recently entered the world of 6.5 Creedmoor after 20+ years of favouring .308win. I strayed to this fad/trendy cal with scepticism and apprehension but a lot of curiosity and sat down...

   Liked On: 02-10-2020, 09:21 AM

8. 
   Moa Hunter liked post by Wingman On thread : 6.5 for smaller game, thoughts?

   90gr TNT or 90gr Nosler Varmageddons with 2206H, BM8208 or 2208 but you will use twice as much powder as the .223rem and the bullets are twice the price too. Faster bullets and more fast burning...

   Liked On: 29-09-2020, 11:08 PM

9. 
   Micky Duck liked post by Wingman On thread : 6.5 for smaller game, thoughts?

   90gr TNT or 90gr Nosler Varmageddons with 2206H, BM8208 or 2208 but you will use twice as much powder as the .223rem and the bullets are twice the price too. Faster bullets and more fast burning...

   Liked On: 29-09-2020, 09:42 PM

10. 
    rupert liked post by Wingman On thread : Switch barrel Brno Fox

    Did the smith stamp any witness marks on the action and barrel to align for repeatable head spacing? All of those cartridges only have 2 thou between go and no go so it would be very easy to get it...

    Liked On: 28-09-2020, 03:02 PM

11. 
    Micky Duck liked post by Wingman On thread : Switch barrel Brno Fox

    I cant seem to find the mag mod pics other than this one 144259 https://www.nzhuntingandshooting.co.nz/f15/300-blackout-barrel-length-60532/

    Liked On: 28-09-2020, 12:40 PM

12. 
    Bill999 liked post by Wingman On thread : .17 Mach IV Barrel

    Had the .17 out running hot last night on the rabbits and hares.. total carnage. It hits so hard even at extended ranges. 149964 149965

    Liked On: 24-09-2020, 10:13 AM

13. 
    Mathias liked post by Wingman On thread : .17 Mach IV Barrel

    Had the .17 out running hot last night on the rabbits and hares.. total carnage. It hits so hard even at extended ranges. 149964 149965

    Liked On: 24-09-2020, 08:44 AM

14. 
    quentin liked post by Wingman On thread : .17 Mach IV Barrel

    Well I managed to free up some workshop time yesterday evening and fitted up the .17 barrel to the CZ 527 action. 126541 126542 The barrel is 24" long and stainless steel with a bore that...

    Liked On: 24-09-2020, 08:32 AM

15. 
    Steelisreal liked post by Wingman On thread : .17 Mach IV Barrel

    Had the .17 out running hot last night on the rabbits and hares.. total carnage. It hits so hard even at extended ranges. 149964 149965

    Liked On: 24-09-2020, 08:27 AM

Page 75 of 159 First ... 256162636465666768697071727374757677787980818283848586878889125 ... Last

• Jump to page: