Hello Dan. Watch these honchos; they'll lead you astray. Some advice. The Waikato beer debate is light compared to what you can expect over yr 270.
Liked On: 17-02-2021, 06:34 PM
Hello Dan. Watch these honchos; they'll lead you astray. Some advice. The Waikato beer debate is light compared to what you can expect over yr 270.
Liked On: 17-02-2021, 05:51 PM
That measure really tells the story. Thankyou for the effort. I use norma brass in four calibres and within each calibre (.308win; 6.5*55 , 30-06spr and 308NMag I find only 0-3grains variance...
Liked On: 16-02-2021, 10:05 PM
That measure really tells the story. Thankyou for the effort. I use norma brass in four calibres and within each calibre (.308win; 6.5*55 , 30-06spr and 308NMag I find only 0-3grains variance...
Liked On: 16-02-2021, 08:39 PM
Error 404 . Not found!
Liked On: 15-02-2021, 10:36 PM
You can buy clip ons from optomitrist
Liked On: 15-02-2021, 08:01 PM
Trolls and strange are likely blocked.
Liked On: 12-02-2021, 01:24 PM
Trolls and strange are likely blocked.
Liked On: 12-02-2021, 01:03 PM
charliehorse. AR2209 IS NOT the same as H414. W760 is though.
Liked On: 10-02-2021, 07:59 AM
WILCO.
Liked On: 09-02-2021, 08:49 PM
No zero stop though.
Liked On: 09-02-2021, 08:48 PM
Theres a mill mill vxr firedot P5 dials on fs section.
Liked On: 09-02-2021, 08:35 PM
Could do it for you but am in NI. I use a 90 tooth tungsten tipped mitre saw. Tape the intended cut line tightly with electrical or masking tape to prevent splitting the edges and use a sacrificial...
Liked On: 09-02-2021, 01:40 PM
Simikar burn rate but very different internal ballistcs. You can safely associate H414- W760 but Ar2209 would require a seperate unique work-up.
Liked On: 08-02-2021, 08:08 PM
The top one is to allow varying powder charge weights by screwing in/out the long screw. The short screw hole is top provide a stop when sliding the charge bar back and forth from powder charge to...
Liked On: 05-02-2021, 09:23 PM