Thread: strelok ballistic app

I've used the pro version for a few years. Rate it highly.

Originally Posted by WillB

Agree. It doesn’t have the vx5 3-15 reticle but I’m using vx6 3-18. You can change the max magnification in settings. Seems to work although I’m dialling so don’t really use it.

It does have the all the Leupold reticles as far as I can see. Only one I couldn t find was the wind plex for the vx5. Bloody handy feature to just wind the mag up or down and see what the values are.

Sent from my SM-G930F using Tapatalk

I wonder what I’m doing wrong then. Are you on Android or iOS? I can’t pull up a vx 5 of any one flavour

Originally Posted by WillB

I wonder what I’m doing wrong then. Are you on Android or iOS? I can’t pull up a vx 5 of any one flavour

Type vx-5 in the search

Yeah nah unfortunately I’ve just checked and on the website vx-5 is only listed for the Android version

Originally Posted by WillB

Yeah nah unfortunately I’ve just checked and on the website vx-5 is only listed for the Android version

Another reason not to have a apple......

Did I need another reason?

Originally Posted by WillB

Did I need another reason?

Not really.

Actually, I think you need reasons to buy a apple.

Originally Posted by Boaraxa

@septic How do you measure the actual measurement ? , iv got the shooter app on my 308 its great on the 7 Rm its 6 or 7 inches high at 500 yards to compensate I put the FPS at 3700 ... haven't tested that theory yet !

Measure from ring centre to gas port but remove the angle factor or it will throw the length out.

Originally Posted by septic

pull the bolt out to a distance equal to the end of the scope and then use a rule to measure roughly centre of bolt to centre of scope

Or use a vernier caliper, measure barrel outside diameter below scope objective lens, measure scope objective diameter and then measure the gap between scope and barrel.

gap + half objective + half barrel diameter = scope height. Geeked out pretty hard on that but the number is very accurate.

Originally Posted by MGNZ

Or use a vernier caliper, measure barrel outside diameter below scope objective lens, measure scope objective diameter and then measure the gap between scope and barrel.

gap + half objective + half barrel diameter = scope height. Geeked out pretty hard on that but the number is very accurate.

So take stock off to do this?

Originally Posted by Gibo

So take stock off to do this?

You could measure the bolt diameter instead of barrel diameter, since they share the same centerline.

Sent from my SM-T800 using Tapatalk

Originally Posted by Gibo

So take stock off to do this?

Guess it depends on the rifle setup, but I can do most of mine like this:



This one is 42.3mm sight in height.

Shit I just measure the gap between the top of the reciever and scope and add 1/2 the bolt diameter and 1/2 the scope diameter.

Originally Posted by Cartman

It does have the all the Leupold reticles as far as I can see. Only one I couldn t find was the wind plex for the vx5. Bloody handy feature to just wind the mag up or down and see what the values are.

Sent from my SM-G930F using Tapatalk

Email the guy that designs the app with the reticle and model you are after he will add it in the next update, hes added 2 for me alone.