Thread: Bushnell AR 3-12×40 query.

Hey guys my scope arrived today and mounted as I could'nt keep them apart any longer.

I noticed what I think is the nitrogen gas port or just beside it there is a cap protruding on a 45 degree angle, one side flush the other raised.

Is this normal or a reason for concern?

Sent from my SM-T210 using Tapatalk

EK9132

Check out this Viseo the scope mounted on the .22 rim fire shows a similar screw at about 1:49


Cheers
Pete

I have the same scope (and mount) and the same little protruding screw... I have seen it on this range f scopes so its definately factory...
What its purpose is i dont know, a similar bushnell scope has a rubber cap in exactly the same place and angle and its the purge point, so i think you are correct...
Grant

Magic thank you both for replying have only just noticed you can see it on the box! My fault.Off to zero tomorrow so will snap a pic of the target and chuck it up in here for anyone else looking to buy one of these scopes. $229 from reloaders was a bloody bargain.

Dan.

Sent from my SM-T210 using Tapatalk

Let us know how you get on with zeroing it, i have yet to put mine on, with luck this weekend or next...
Thanks Grant

Looks like a good enough scope for an AR.

Just need to get an AR to put one on.

Cheers
Pete

Originally Posted by EK9132

Magic thank you both for replying have only just noticed you can see it on the box! My fault.Off to zero tomorrow so will snap a pic of the target and chuck it up in here for anyone else looking to buy one of these scopes. $229 from reloaders was a bloody bargain.

Dan.

Sent from my SM-T210 using Tapatalk

Bugga the Zeroing ... Bring on the Mosin !!!!!!!!!

Haha have got a busy night on the range have some loads to test for the AR and Howa then flamethrower action with the Mosin carbine :-) looking forward to it Sean.

Sent from my SM-T210 using Tapatalk