Thread: Kiwi made howa mini bottom metal

I've put a far amount of time into getting theses where I think they are good to go.
No more dropping factory mags accidentally. The release is built to be enclosed and protected. It also is obvious when not engaged. Torque won't crack them like factory plastic version.

Next will be to take my own flush mag design.


Cheers

Awesome work Rob, this great to see! PM sent.

That's pretty cool, well done that man!

Nice job, pm sent

Mine arrived today.
Looking good.
Thanks @robhughes-games

Sent from my SM-S711B using Tapatalk

Mine too. Thanks @robhughes-games.

Mine arrive and is fitted to rifle. Super stoked with it. Factory mag needed a tiny tweak to fit. Mag is locked in tight and not all loose like it was Factory plastic version. I haven't been to range but have run over 100 rounds through with 100% reliable feeding; which is certainly better than the full Factory version. The mag catch is.a huge improvement.

I haven't fitted mine but both my 223 and my 7.62 mags fit without any trimming or modification. My shortened 7.62 mag is a gnats whisker too short and doesn't quite latch. I think a light trim of the mag floorplate will sort that though.

@Cowboy

I’m too unco to figure how to PM on my phone. But am keen for one if you still have availability; how much to be blessed by one of these?

Originally Posted by frape787

I’m too unco to figure how to PM on my phone. But am keen for one if you still have availability; how much to be blessed by one of these?

Hi mate.

Check out website hgprecision.net or email me at robhughesgames@gmail.com
They are $280 + shipping.
I'm.away fishing till next weekend though.

Cheers

Any chance you would look into a flush/hinged floor plate version in the future?

Sent from my CPH1931 using Tapatalk

I'm planning to do something down that road. Likely a mag that's flush though.