Don't know why but I shot an Adams Arms piston build and found the recoil impulse to be a lot less snappy than a DI gun
Don't know why but I shot an Adams Arms piston build and found the recoil impulse to be a lot less snappy than a DI gun
Depends on the DI setup
Mates gun almost yars fillings out, but my midlength 16" is smooth as silk even though its quite overgasses
Going to play with a rifle length 16 when I'm back and see ho it runs comparatively
A gun that drops brass at 5 o clock is also alot smother than one that puts it a 2
If the bolt could be locked back on the AR without removing hand from the trigger grip then I would say they are the dogs bollocks and I would get one, I probably will anyway once the new Arms Act amendments have been finalised if the pistol grip rule stays as is. I really want a go with an SL8 though. Might have to bite the bullet and get an E-Cat.
Magpul BAD, various ambi bolt release lowers exist.
KAC is $haha
Mega Arms are really really nice and do an ambi billet lower. They also made a realllly nice monolithic tube upper, but they stopped because LMT patented mono uppers
Too me its NOT about getting a piece of ART , its about getting a reliable rifle , and it took some work to work the AR-15 into a reliable system , from the ammo/powder to the twist , chromeline bore & chamber , to the chroming inside the Bolt carrier , to the barrel lenght , to different buffers , full auto BCs , different firing pins , etc , etc , muck around with any of these & substite cheaper compotents etc , and you get a rifle thats no where near the real M16A1 preformance .
Later Chris
Bookmarks