Thread: Sako rings for 34mm scope

Hi all, Looking at upgrading to a ATACR 4-16x42 F1 on my Sako 75, what 34mm rings you guys using and height would fit for this scope?

Rail?

Sako optilock rings and bases, or, if you've had a rail fitted, take your pick

B

Near rail and then your pick of rings

If ya hoping to get something decent through Beretta NZ ya fuked, I didn't want to use a rail on my 6-204 T3 ( because it looked friggen ugly ) & the only 34mm rings & bases they could supply were extra extra high, ugly useless & way over priced.
I ended up getting some Leupy bases ( still higher than they need to be ) & leupy 34mm rings off KiwiGreg & they were better value & quite tidy.

I'm not using em at the mo so could be keen on selling but not sure if T3 will fit a S75's ?

These guys make a pressure (tap on rail) fits the dovetails of the sako's awesomely made and last one i ordered was here in a week...

Near Manufacturing

I now have rails on all 3 of my sakos. A near rail and two waitaki engineering rails.

Sent from my SM-G935F using Tapatalk

Originally Posted by josh86

I now have rails on all 3 of my sakos. A near rail and two waitaki engineering rails.

Sent from my SM-G935F using Tapatalk

What are the better of the two?

Both good. For cost I would go waitaki and also dose a really good job.

Sent from my SM-G935F using Tapatalk

Gun city was/is selling a 2 piece picatinny rail which slides onto sako dovetail,, made by Tier One.

EAW aqlso make a slide on mount for sako 75/85 https://www.optics-trade.eu/nz/mount...-75-34-mm.html

Originally Posted by tikka

What are the better of the two?

From an engineering perspective the NEAR rail hands down. Lower and fits into the dovetails with an integral recoil lug. No drilling and tapping.

I've had both.

B

Thanks for all the input guys.