Thread: 9mm and rimfire bolt action

Hey guys, thanks for the comments. appreciated!

Yes, I started a company and it's called Marshal Precision

I can tell you that it was quite a via crucis to get to where i am at now.
Some people that should know the laws... didn't... and to show them I was not converting any AR15 was the hardest part
as it takes AR grips.

We are still around 2 months away as w have to send 2 rifles to be tested and approved by the Police Armoury in Wellington.

So, just hope everything goes smooth from here.

Thanks again!

MFG

Originally Posted by xring

Hey guys, thanks for the comments. appreciated!

Yes, I started a company and it's called Marshal Precision

I can tell you that it was quite a via crucis to get to where i am at now.
Some people that should know the laws... didn't... and to show them I was not converting any AR15 was the hardest part
as it takes AR grips.

We are still around 2 months away as w have to send 2 rifles to be tested and approved by the Police Armoury in Wellington.

So, just hope everything goes smooth from here.

Thanks again!

MFG

Best of luck - I look forward to developments!

This is cool. +1 on glock mags.

Thats the ducks nuts. The website is pretty slick too. Maybe slicker than goose shit?
Hope you don't loose your mind dealing with plod.

Your rifle at the sika show looked good. Maybe the rear but plate is not long enough?

Check out my pump action sten.....maybe we can go in business together

tardy reply guys. no problem with ar parts. approved by AO.
this is the final rifle with a new retractable stock. some details here and there
to polish but 95% done.

Originally Posted by xring

tardy reply guys. no problem with ar parts. approved by AO.
this is the final rifle with a new retractable stock. some details here and there
to polish but 95% done.

Attachment 125928

if only a lefty. Still I could shoot that easy enough balanced on the pistol grip while cycling the action.

@GDMP its full on. Have a look at our web site:

www.marshalprecision.com

cheers

Cool NZ design! And a sound decision not to go so ridiculously light you can't be accurate when unsupported.

For quicker follow-up shots, a M1917 style backwards bent bolt handle would allow middle finger triggering.

Is there any of these out in the wild that people are using?

@Gun nut these fine fellows may well be able to help with that bit of 9mm barrel blank you were after.......

The guys left the country unfortunately mate, I did buy a few of his actions and his last 9mm rifle but no spare barrels unfortunately

I have a couple of his actions and some barrel blanks too but no time to put them together at the moment. Will sell one of the stainless actions if someone is keen on a project. Owes me $300

Pm’d