Welcome guest, is this your first visit? Create Account now to join.
  • Login:

Welcome to the NZ Hunting and Shooting Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

Terminator Alpine


User Tag List

Results 1 to 15 of 26
Like Tree19Likes

Thread: Eccentric over barrel rifle suppressors - anyone know?

Threaded View

  1. #22
    Member Cordite's Avatar
    Join Date
    May 2017
    Location
    NZ Mainland (Dunedin)
    Posts
    5,538
    Quote Originally Posted by Chilli_Dog View Post
    Sounds like a familiar design.... mine was 405mm long and 2" dia, it is pretty heavy though, if I get my mits on another barrel I might try for some slots near the muzzle end, or maybe just fluted with ports at the bottom of the flutes. The only tricky bit with your idea is getting the crown sorted depending on how deep you counter bore it, maybe a brass rod that is a good fit for your hole with the end turned/filed/ground to the same angle as the drill bit and some valve grinding paste. Im not really convinced the baffles in mine do anything but I have a lot of relatively small ports
    Yes, prob with long counterbore is keeping it concentric with the bore, or the crown will not be at 90 degrees to the bore either. I think main thing is to counterbore to somewhere where there is good rifling (that is why this rifle is getting chopped), less important to have a beautiful looking crown. Some dude out there did experiments with simply hacksawing a new hunting rifle one inch at a time and shooting the rough end with only obvious burrs removed, no effect detected on accuracy. Anyway, if you use a drill with more of an angle on the cutting edges it's self centering.

    I have an alternative idea taken from overbarrel silencers, where a barrel protector sleeve is often added. You can extend that sleeve forward of the muzzle right to/through the front of the silencer and perforate it to your heart's content. A small barrel counterbore of 2 inches can still be done, with side venting ports, and the sleeve can be perforated over those ports. Baffles can be welded to the sleeve if desired.

    Both solutions seek to address @gundoc's stated/hated no. 1 problem with eccentric suppressors - alignment.

    Name:  sleeve eccentric.jpg
Views: 553
Size:  145.6 KB
    Last edited by Cordite; 03-12-2018 at 10:22 PM.
    An itch ... is ... a desire to scratch

 

 

Similar Threads

  1. Rifle barrel to australia
    By akaroa1 in forum Firearms, Optics and Accessories
    Replies: 3
    Last Post: 29-12-2015, 09:32 AM
  2. over barrel suppressors
    By longrange308 in forum Firearms, Optics and Accessories
    Replies: 13
    Last Post: 06-07-2012, 11:38 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!