Thread: Calibers

One of maiseys twist on an off brakes on it with a 26" bbl atleast a non ear exoloding offhand quick shot will be possible . Sonething a edge is not capable of

Originally Posted by Tussock

Why couldn't you shoot an un-braked 338 Edge offhand?

You can and i have done it with my light and heavy edge, blew huge holes in sika under 100 yrds away.

The light one was fine in an eyeball jiggly kind of a way

Originally Posted by Tussock

Why couldn't you shoot an un-braked 338 Edge offhand?

Have u tried it? Unbraked i mean lol.. freakin boots!!!!

Plus the wingman can be formed from two parent cases one just requires alot more steps in the forming process! The one we basing it of is simple neck down and fireform through a billet chamber!!!

Plus redding type s dies are available

They fire them, but look between their shoulder blades the next day Buff guides in the NT firing 6lb guns in 458 (?) stops em but not pretty on the shooter.

Its kinda like the old saying goes!!

Why be cold when you can be warm lol

If Mr kiwi Greg would be kind enough to post the capacity of the 7 375r? as all my cases went with the reamer

To the shoulder line with 2225 since you have it an water as well?

I'll pop home for lunch and get the 7mm wingman will be good to see

Sent from my GT-I9300T using Tapatalk 2

Here it is gave the misses the call

Capacity
Us869. . . . ... .90.2
2225... . . . . . . 83.5
Water . . . . ...91.8

This was over 3 cases and average it was hard to see when at shoulder level and I was on the empty side. It's a size form an load case, not the 4 neck downs inside ream out side turn and anneal I found with the 7 375r case and not Hornady brass either

Will be good to compare as they are similar but not the same

Sent from my GT-I9300T using Tapatalk 2

Its a simple form so anyone can do it... should be possible to form as you shoot if wanted...
I think the fact that forming simplicity, top end brass and type s dies are possible will make the 7-375 obsolite

Not to mention stw dakota type capacity cases

The brass is in wellington now for the wingman now!!

How much for a packet of brass Quentin ???

This looks to be Norma 404 jeffrey brass that can have a few mm trimmed from the neck, is this what your selling quentin, and a price please.

Originally Posted by 7mmsaum

This looks to be Norma 404 jeffrey brass that can have a few mm trimmed from the neck, is this what your selling quentin, and a price please.

No trimming required

Sent from my GT-I9300T using Tapatalk 2

Originally Posted by tui_man2

No trimming required

Sent from my GT-I9300T using Tapatalk 2

A few possibilities with that as a parent case mr Abe.
I have decided to be timid and go .280AI
It will be easier as well. I doubt I would get a mag for the 93 to hold that case.


Sent from my iPhone using Tapatalk. So please forgive my sausage fingers!!!